The UNIX version of PREPRO2002 comes with FORTRAN
source codes, in compressed form.
 
1) To uncompress and install, copy INSTALL.BAT and
   PREPROZ.Z to your hard drive. Execute INSTALL.BAT -
   WARNING - DO NOT execute PREPROZ.Z, or the system
   will not properly install into a directory structure.
   After installation you can delete PREPROZ.Z and
   INSTALL.BAT.
 
2) This system comes with batch files to compile and
   load all of the codes, and clean up the final form
   of the PREPRO directory. Execute the batch file
   for your type of computer, e.g., SUN.BAT, SGI.BAT,
   CRAY.BAT, etc. This could take between 5 and 45
   minutes to complete.
 
   If the codes EVALPLOT and COMPLOT fail to compile and
   load then you may need to change the path in the
   Makefile to the directory that contains your X-Windows
   routines, i.e. /usr/lib/X11
 
3) To VERIFY proper installation, it is recommended
   that after installation you execute VERIFY. This
   is a batch file that will run the codes in sequence.
   The final two codes will display the calculated
   cross sections (EVALPLOT), and compare the results
   you calculated to a standard set of results (COMPLOT).
   Difference of about 1 % are acceptable; larger
   differences indicate an installation problem.
 
4) If you have any problems notify the Nuclear Data
   Section, IAEA, Vienna, Austria.
 
   services@iaeand.iaea.or.at