The IBM/LINUX version of PREPRO2007 comes with
executable codes, in compressed form.

1) To uncompress and install, copy INSTALL.BAT and
   PREPROZ.Z to your hard drive. Execute INSTALL.BAT -
   WARNING - DO NOT execute PREPROZ.Z, or the system
   will not properly install into a directory structure.
   After installation you can delete PREPROZ.Z and
   INSTALL.BAT.

2) To VERIFY proper installation, it is recommended
   that after installation you execute VERIFY. This
   is a batch file that will run the codes in sequence.

   The final two codes will display the calculated
   cross sections (EVALPLOT), and compare the results
   you calculated to a standard set of results (COMPLOT).
   Difference of about 1 % are acceptable; larger
   differences indicate an installation problem.

   If the codes EVALPLOT and COMPLOT fail to execute then
   you may need to recompile them and change the path in the
   Makefile (LINUX.MAK)to the directory that contains your
   X-Windows routines. i.e. /usr/lib/X11. In this case you
   will need the FORTRAN source codes that are contained in
   the UNIX distribution.

3) LINUX systems now vary from one type of computer to another,
   so that the LINUX executables included in this package may
   not run on your computer. In this caae you MUST re-compile
   the codes; start from the UNIX package that icludes source
   codes and use the LINUX.mak as a makefile.

4) If you have any problems notify the Nuclear Data
   Section, IAEA, Vienna, Austria.

   services@iaeand.iaea.or.at